These are 3d designed by us to have holes sized for most average screws and a reinforced design to help stop them from snapping. These are 3d printed by us to be as durable as possible. They work well, used by us & tested by us many times to make sure they work well for the application of fastening these to the wall to hold PEX water line to a wall or other surface where you need to hang PEX water line. These could also work on a ceiling. We recommend these be placed around every 1’ to 2’ on average for the best strength.

No screws or nails included

As with anything plastic, although strong and durable, do not try to over-tighten these to any surface at full speed or you could damage the clip or the PEX. Tighten these down until the clamp feels snip against the pipe and hold well to the wall. Screws do not have to fully come flush with the wall/clamp to hold well.

The screws we use that we recommend for this application are simple fasteners like you see in the picture, they drive into surfaces well and have large heads to help make everything stronger and hold well.

If you have questions just let us know. We sell these in packs of 5.